Belts are normally continuous and Bi-State Rubber installs the strongest hot vulcanized splice on the market. We can also provide your belt with ends prepared for plate fasteners or our special recess hinge fastener.

 

 

 

 

 

 

 

Holes and Patterns

Shown here are two of the more common drain hole patterns. Drain hole patterns available in 5/32″, 3/16″, 1/4″, 5/16″, 3/8″, 1/2″ (contact us for special requests).

 

How to measure a belt

I.C. is inside circumference. This is the most accurate, but can only be measured off the machine or from a spare belt.
O.C. is outside circumference. This is most commonly used, but has drawbacks. Belt thickness must be considered. Belt can be measured inside the machine by taping short distances and marking or measuring c.c. on cleats and total cleat count. Special concern to where take-up is set must be noted on either method of measuring.

 

Base Belting

3 ply and 4 ply belting available with the industry’s most durable covers. Available in 3/16″ x 1/16″, 1/4″ x 1/16″ and 3/8″ x 3/32″.

 

Cleats and Guides

 

A variety of hot vulcanized tumbling cleats and tracking guides available.

Contact Bi-State for more information.

 

We also provide replacement belts for: Wheelabrator, Pangborn, Viking, Bronco, Kelco, C/M, Sinto, BCP, DeLong, MP Tech, Coyote & Gibson Equiment.